Results 1 to 4 of 4

Thread: Darkened edges on mugs

  1. #1

    Darkened edges on mugs

    Has anyone else had the issue where the edge of the engraving on a mug/H2O bottle or the like, is darkened, almost looking burned, or the laser didn't go deep enough? We have tried to adjust by moving the image/text over to the left but if you go too far it does it on the left hand side. Just curious if anyone has figured out a solution.

  2. #2
    Anyone? Anything? Have also sent a question into customer service with no reply yet.

  3. #3
    Administrator TimG's Avatar
    Join Date
    Jan 2011
    Location
    Orrville, OH
    Posts
    173
    Blog Entries
    24

    Re: Darkened edges on mugs

    Does this problem appear only on some specific mugs or water bottles, or is it all ZHZO items? One thing to try is re-calibrating the Z-axis; instructions can be found in this document, #4 (pages 8 & 9). http://www.laserengravings.info/Lase...er_Support.pdf

  4. #4
    Hey Tim,
    We have tried that, and it doesn't seem to be product specific. It tends to be hit and miss with the image and wording. I just did a ZHZO39 and it was a butterfly with a name below it and it did it right on the edge, leaving it black, like it isn't engraving all the way through. If you'd like I can send you photos of what is going on.

    Thanks, Jessica

Tags for this Thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •