Q&A: How to "Restart" a Lasering Job

Question:
Occasionally we will send a large job to the engraver. Sometimes we have the red light on to check alignment, sometimes we notice some problem that requires adjustment. In either case, we would like to reset the engraver to re-start from the beginning, rather than waiting for it to finish a lengthy run.

What is the recommended procedure for dumping the "print cache"? Switching the engraver off works, but it seems like there should be an easier way.

Thanks,
Dennis Field

Answer:
After pressing the orange button to stop the engraving, press the left arrow button on the machine to return the head to the top left position. You may then turn off the red light and press the green button to start engraving from the beginning.

Franklin