Printing From CorelDraw is for the more advanced, but very doable. Just print to the L-Solution printer that is already installed on your system. Use the printer properties to set speed/power/etc.

Be extra careful to check all the properties. Corel does not save properties with each file. A screen print of the gravostyle properties for that particular item would be a good start. A couple other pointers:

If you get an error - UC Board Error, on the print properties page click the about tab. Click the big laser button. Change the output to the USB port.

If you plan to do any cutting in Corel, the outline must be set as a hairline.

Have fun!